New Holland T8010 Manual page 170

Hide thumbs Also See for T8010:

Table of Contents

Disassembling the Countershaft with Creeper Speed Clutch

Remove the two seal rings from the shaft.

Use a hydraulic press to remove the front bearing

cone and the creeper driven gear.

NOTE: The front needle thrust bearing and two

bearing thrust washers will come off with the front

bearing cone.

Section 21 - Transmission, Drivelines - Chapter 4

Remove the caged needle bearing.

Remove the rear needle thrust bearing and the two

bearing thrust washers.

Chapters

Table of Contents

T8020 T8030 T8040