New Holland T8010 Manual page 566

STEP 67
Install lifting eyes and properly support the steering
knuckle. Guide the axle shaft outer yoke into the
steering knuckle.
STEP 68
Use the following procedure to make sure the kingpin
bearings are seated.
1. Apply a layer of grease to the inner ring bearing
surface.
2. Properly support the steering knuckle. Install the
lower king pin bearing cap WITHOUT shims.
3. Install the upper king pin bearing cap WITHOUT
shims.
4. Tighten all bolts to a torque of 156 to 170 Nm
(115 to 125 lb. ft.).
DO NOT rotate the steering knuckle.
Section 25 - Four-Wheel Drive Front Axle - Chapter 10
RR98K114
RR99K258
25-10-21
STEP 69
Remove the king pin bearing caps after verifying that
the bearings are fully seated and install the king pin
shims.
NOTE: The same thickness king pin shims can be
used on top and bottom to serve as a starting point to
determine the new shim packs required.
STEP 70
Install the king pin caps. Evenly tighten the bolts in a
crossing pattern to a torque of 156 to 170 Nm (115 to
125 lb. ft.).
RR99K244
RR98K070