New Holland T8010 Manual page 568

STEP 74
Lubricate the two steering cylinder clevis pin bushing
O-rings with grease. Make sure an O-ring is installed
on each side of the steering cylinder at the clevis pin
bushings. Make sure the flat on the head of the clevis
pin is turned toward the axle housing. Install the
clevis pin. Insert a cotter pin through the clevis pin.
Install the steering cylinder on the opposite side of
the FWD axle, if removed.
Section 25 - Four-Wheel Drive Front Axle - Chapter 10
RR98K071
25-10-23
STEP 75
2
1
Use the identifying mark made during disassembly to
position the wheel stop. Install the wheel stop (1), the
clevis locking pin (2), and the clevis retaining pin (3).
Install the wheel stop on the opposite side of the
FWD axle, if removed.
3
RR98K105