New Holland T8010 Manual page 939

STEP 45
Install the hex-head bolt, washer, spacer and nut.
Tighten it to a torque of 82 to 106 Nm (60 to 78 lb.
ft.). Repeat for the other vertical lifting link.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
26-21
35-11-18
STEP 46
Insert a hitch swivel pin through the inside hole at the
bottom of the vertical lifting link. Lift up the draft arm
and insert pin. Pin must be clean and free of oil,
grease, anti-seize compound, etc.
NOTE: Be sure the lift link is properly timed.
NOTE: Be sure there is alignment of parts. Refer to
Steps 6 and 10.
STEP 47
Install the locking flag plate as follows:
1. Insert the locking flag plate.
2. Install the bolt and nut. Tighten to a torque of 82
to 106 Nm (60 to 78 lb. ft.).
26-33
76-5