New Holland T8010 Manual page 626

STEP 4
Remove the wheel and tire assemblies from both
axles.
STEP 5
Raise the rear of the cab. See Cab Raise Procedure
in this Service Manual.
STEP 6
1
Proper ly suppor t the cab by placing blocking
between the cab rails and the transmission. Make
sure that no wires or hydraulic lines are pinched.
Lower the cab and remove the cab jacking bolt (1)
Section 27 - Rear Axle - Chapter 1
STEP 7
86S1
Remove the cab mounting bolt (1) from the cab
mount. Lifting bracket (2) can be left in place.
STEP 8
Remove the axle bolts that retain the draft pin wiring
tub bracket (1) and the hitch cylinder hose bracket
(2). Move the brackets out of the way.
77S36X
STEP 9
Remove a bolt from front and rear of the axle housing
and install a guide dowel in each bolt location.
27-1-7
1
2
2
1
RD02F104
RD06A002
RD06A003