New Holland T8010 Manual page 300

Hide thumbs Also See for T8010:

Table of Contents

Remove the hub seal backing O-ring and discard.

Inspect the needle bearings (1) and composite

washer (2) for wear or damage. If bearings and or

washer are worn or damaged, the FWD hub will have

to be replaced. Bearings and washer are NOT

Remove the three shaft seals and discard.

Section 21 - Transmission, Drivelines - Chapter 6

Remove the retaining ring for the emergency brake

clutch assembly.

IMPORTANT: Mark the shaft and hub (1) for proper

Place a puller over the shaft assembly and using the

two threaded holes in the emergency brake hub

assembly, install two bolts (1) as shown and pull the

assembly from the shaft.

Using tool 380002454 to compress the Belleville

springs, remove the retainer ring.

Chapters

Table of Contents

T8020 T8030 T8040