New Holland T8010 Manual page 172

Hide thumbs Also See for T8010:

Table of Contents

Use a hydraulic press to move the shaft through the

clutch plate carrier, spacer and the (2nd-4th-6th)

speed driven gear.

Remove the snap ring from inside the clutch plate

Remove the backing plate, friction plates, separator

plates and reaction plate (thicker than separator

plate) from the clutch carrier.

Section 21 - Transmission, Drivelines - Chapter 4

Remove the spacer.

Remove the (2nd-4th-6th) speed driven gear and

Turn the shaft over and use a hydraulic press to

remove the rear bearing cone (1st-2nd) speed driver

gear and steel ball.

Chapters

Table of Contents

T8020 T8030 T8040