New Holland T8010 Manual page 969

Hide thumbs Also See for T8010:

Table of Contents

Setting Verification

Verification of the toe in setting is done by taking plumb bob measurements from the rims. Be sure the axle is still

dead centered before starting the checking procedure.

Install a magnetic base (1) for a dial indicator on the

front inside of the rim. Locate the base on the rim at

the center line of the axle (so that it is on the most

forward part of the rim).

Hang a plumb bob (2) on the base. Install a spacer of

other suitable device (3) so that the distance from the

string to base remains constant.

Accurately mark the point where the plumb bob

intersects the floor. Repeat the procedure at the rear

inside of the rim.

A total of four marks will be made, two from each tire.

Accurately measure and record the distance across

the two rear marks. Repeat the measurement across

t h e f r o n t t w o m a r k s . C o m p a r e t h e t w o

measurements. The distance across the front marks

should be within 3 mm of the rear measurement. The

front distance should never be larger than the rear

If not within specifications, adjust the tie rod tubes

equally to correct the toe in setting. Rotate the

adjustment tube 1/4 turn at a time and check the toe

setting by marking four new points using the plumb

bob and string. Be sure the axle remains dead

centered after each adjustment is made to the tie

Section 41 - Steering - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040