New Holland T8010 Manual page 311

STEP 231
Measure the distance between the top of the hub
flange (1) and the top of the piston (2).
If dimension is greater than 29.7 MM, use one spring
spacer.
If dimension is greater than 31.2 MM, use two spring
spacers.
If dimension is less than 29.7 MM, DO NOT use
spring spacer.
Remove piston, spacers, friction plates and backing
plate from the hub.
If spring spacer is needed, it will be placed between
the Belleville springs and the retainer ring during
assembly.
STEP 232
Install the five Belleville springs over the shaft as
shown.
IMPORTANT: Belleville springs must be aliened and
centered so that they do not catch on the shaft when
they are compressed.
Section 21 - Transmission, Drivelines - Chapter 6
1
2
RD05K060
RD05K023
21-6-58
STEP 233
1
Place the spring spacer(s) (if required), locking ring
(1) and retaining ring (2) over the shaft.
STEP 234
Center Tool 380002454 on the Belleville springs,
compress the springs and install the retaining ring
into the ring grove.
IMPORTANT: Make sure retainer ring is sitting
inside the locking ring and fully seated in the ring
groove before removing compression tool.
2
RD05K022
RD05K040