New Holland T8010 Manual page 827

Hide thumbs Also See for T8010:

Table of Contents

Install new O-rings onto the solenoid bodies. Install

the two springs and a solenoid block onto each side

of the valve body. Be sure that the 27.16 mm (1.069

inch) inner spring is on the return side.

Tighten the retaining screws to a torque of 10 to 13

Nm (7 to 10 lb. in.).

Section 35 - Hydraulic Systems, 3PT - Chapter 4

Install new O-rings on the solenoids. Install the

solenoids and tighten the mounting screws. Be sure

the solenoids are positioned on the bodies as noted

during disassembly.

Apply petroleum jelly to new O-rings (1) and install

them onto the valve ports. Apply petroleum jelly to

the two signal check springs and install them into the

ports (2) in the valve.

Chapters

Table of Contents

T8020 T8030 T8040