New Holland T8010 Manual page 706

Hide thumbs Also See for T8010:

Table of Contents

Install the eight mounting bolts and torque to 95 Nm

(70 lb. ft.).

IMPORTANT: Before installing the seal, check the

rolling torque of the output shaft. See Reversible PTO

Output Shaft Bearing Adjustment Section.

Apply Loctite® 721 to the O.D. of the seal and seal

Press the seal in until the face of the seal (1) is 41 MM

from the outer face of the housing (2).

Place petroleum jelly or grease in each coupler

retainer ball hole.

Section 31 - PTO - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040