New Holland T8010 Manual page 357

Hide thumbs Also See for T8010:

Table of Contents

Remove the two bolts that attach the rockshaft

sensor shield to the hitch support C-bracket.

NOTE: Be sure to remove hitch position sensor

(potentiometer) prior to removing the hitch lift

cylinders. If the cylinders are removed first, there

may be excessive travel of the rockshaft, which would

damage the sensor.

Remove the nut from the link assembly.

Section 21 - Transmission, Drivelines - Chapter 8

Remove pin and free the upper end of the hitch lift

Remove the bolt, locking flag plate pin and free the

lower end of the hitch lift cylinder. Remove the

Hold the left nut on the tie rod and turn the right side

nut (shown).

Chapters

Table of Contents

T8020 T8030 T8040