STEP 179
1. MARK ON CARRIER FACE
Remove snap ring. Make a mark on carrier face that
will align with mark on the end of shaft. This mark
will help align carrier on the shaft during assembly.
NOTE: If a new part replaces an old part, make a
mark on the new part that is in the same position as
the mark for the old part.
STEP 180
Press the splined rear end of the shaft so the shaft
moves through the clutch plate carrier.
Section 21 - Transmission, Drivelines - Chapter 4
T95474
1
2
468L72
2. MARK ON SHAFT FRONT
T95476
21-4-50