New Holland T8010 Manual page 646

Hide thumbs Also See for T8010:

Table of Contents

Use a suitable tool and rotate the axle until the sun

and planet gears engage.

Install a few axle housing mounting bolts and tighten

until the axle housing contacts the rear housing

flange. Remove the aligning dowels.

Move the draft pin wiring tube bracket (1) and hitch

cylinder hose bracket (2) into position. Install the

remaining axle bolts.

Section 27 - Rear Axle - Chapter 1

Tighten the axle housing mounting bolts to a torque

of 232 to 262 Nm (171 to 193 lb. ft.).

Install the cab mount bolt (1). While holding the plate

(2) torque the bolt to 47 to 61 Nm (35 to 45 lb. ft.).

Install the cab jacking bolt (1) and bearing (2). Raise

the cab and remove blocking. Lower the cab, remove

cab raising equipment.

Chapters

Table of Contents

T8020 T8030 T8040