New Holland T8010 Manual page 935

Hide thumbs Also See for T8010:

Table of Contents

Pins must be clean and free of oil, grease, antiseize,

compound, etc. Orient pin with bearing surface

outboard. Insert a rockshaft pin. Use a wooden block

to tap the pin until it is seated in place. Replace the

other rocker pin. Adjust the hoist to allow the pins to

slide easily.

Insert new pin-to-rockshaft retainers at the ends of

both rockshafts.

If tie rod was disassembled, install a nut (1), washer

(2) hitch retaining bracket (3) and prevent torque nut

(4). With a minimum of three threads (5) showing,

torque the nut to 490 to 550 Nm (362 to 410 lb. ft.)

Section 35 - Hydraulic Systems, 3PT - Chapter 11

Install the tie bolt. Install the washer and M24 nut on

the opposite (left hand) side.

While preventing the M24 nut on the right-hand side

from rotating (shown above), tighten the left-hand

M24 nut to 490 to 555 Nm (362 to 410 lb. ft.).

NOTE: Make sure the retaining washer (1) stays in

the split ring counter bores when tightening the tie

Tighten all 14 bolts for the hitch support C-brackets

to a torque of 845 to 950 Nm (624 to 700 lb. ft.). The

bolts must be tightened in the sequence shown in the

Chapters

Table of Contents

T8020 T8030 T8040