STEP 31
Connect the battery cables at the starter.
STEP 32
Complete installation as follows:
1. Remove the jack stands, jack and front splitting
stand.
2. Install the FWD drives shaft. See FWD drive
shaft removal and installation information.
3. Recharge the A/C system. See A/C Section in
this Service Manual.
4. If required, install the front weight bracket and
weights.
5. Remove the blocks from the wheels.
Section 21 - Transmission, Drivelines - Chapter 2
RD05N104
96R28A
21-2-11
STEP 33
2
Connect the positive (1) negative (2) and battery
cables.
STEP 34
When tractor assembly is complete, run the tractor
and check for hydraulic leaks.
Check the fluid level in the transmission and add as
required.
1
RD02E069