Speed To Range Transmission Split; Removal - New Holland T8010 Manual

Removal

STEP 1
Prepare for removal as follows:
1. Park the tractor on a hard, level surface.
2. Put the shift control lever in PARK.
3. Fully lower the rear three-point hitch.
4. Stop the engine and remove the key.
5. Put blocks behind and in front of the rear wheels.
6. Remove the hood, following the procedure in the
Tilt and Fixed Hoods section of this manual.
7. Remove the cab, following the procedure in the
Cab Raise/Removal and Installation section of
this manual.
8. Remove the fuel tanks, following the procedure in
th e Fu el Ta n k /Fu e l S en d er R e moval a n d
Installation section of this manual.
9. Remove the MFD drive shaft, following the
procedure in the MFD Drive Shaft section of this
manual.
Section 21 - Transmission, Drivelines - Chapter 3

SPEED TO RANGE TRANSMISSION SPLIT

96RS28A
STEP 2
Drain the transmission fluids from the range, speed,
and rear frame. Drain fluid into clean drain pans.
NOTE: The transmission capacity is approximately
172 liters (45 gallons).
4
91S17