New Holland T8010 Manual page 960

Hide thumbs Also See for T8010:

Table of Contents

Pull up on the cab floor mat and install the left

console heat duct into the cab floor duct. Install the

retaining screw. Position the right console heat duct

and install the retaining screw.

Pull up on the cab floor mat and install the two

screws (1) in the left side of the upper console panel.

Repeat this procedure for the right side. Connect the

electrical plugs to the switches and upper indicator

lights. Install the circular heater duct outlets into the

upper console panel.

Section 41 - Steering - Chapter 1

Connect the electrical plugs to the ignition switch and

the light switch. Install the two screws (1) for the

lower console panel.

Make sure the transmission shift lever is in PARK.

Start the engine and check the operation of the

steering hand pump. Check the hydraulic fluid level.

Add fluid as needed. Turn the engine off and remove

the key. Remove the blocks in front of and behind the

rear wheels.

NOTE: Do not hold the steering wheel during

Chapters

Table of Contents

T8020 T8030 T8040