Special Torques; Specifications; Pump Drive; Removal - New Holland T8010 Manual

Bearing Cage Bolt .......................................................................................................... 55 to 60 Nm (41 to 44 lb. ft.)
Hydraulic Drive Pump Assembly Mounting Bolts............................................................ 52 to 61 Nm (38 to 45 lb. ft.)
Driven Gear Shaft End Play.............................................................................0.026 to 0.1 mm (0.001 to 0.004 inch)

Removal

STEP 1
1
4
3
Use identification tags to mark the hydraulic lines.
Cap the lines and open fittings. Remove the charge
pump and filter (1). Refer to the Charge Pump
section of this manual. Remove the transmission
filter with base (2) and the hydraulic PFC piston
pump (3) from the hydraulic pump drive (4). Refer to
the PFC Piston Pump section of this manual for
transmission filter base and PFC piston pump
removal.
NOTE: Provide open access to the pump drive by
blocking the front wheels and properly supporting the
rear axle. Loosen the six wheel bushing bolts and
move the wheel outward on the axle.
STEP 2
Remove the three hydraulic line clamps (1) on top of
the hydraulic line support bracket.
Section 21 - Transmission, Drivelines - Chapter 9

SPECIAL TORQUES

SPECIFICATIONS

PUMP DRIVE

2
RD02D002
1
RD02D023
21-9-3
STEP 3
Remove the two mounting bolts (1) from the
hydraulic line support bracket.
STEP 4
Remove the two longer top mounting bolts and the
six shor ter bolts from the pump drive mounting
flange. Remove the pump drive assembly.
1
RD02D021
RD02D026