New Holland T8010 Manual page 516

Hide thumbs Also See for T8010:

Table of Contents

Installation of Carrier Assembly to Axle Housing

Thoroughly clean the inside of the axle housing.

Remove any burrs and nicks from the carrier housing

and axle housing mounting surface.

Apply Loctite 515 Gasket Eliminator to the axle

housing mounting flange and around the outside of

each bolt hole.

Section 25 - Four-Wheel Drive Front Axle - Chapter 8

Install the carrier assembly into the axle housing.

Appl y Locti te 271 to all bolt threa ds p r i or to

installation. Install the hose clamp on the lower bolt

(1) from where it was removed. Install washers and

bolts and tighten to a torque of 135 to 155 Nm (100 to

115 lb. ft.).

Assemble axle shafts and wheel end components,

following procedures shown in axle disassembly

information.

Clean drain plugs and install in carrier housing and

planetaries. Fill with the lubricant specified in the

operator's manual to the proper levels.

Inspect wheel ends and housing for oil leaks. Take

immediate corrective action when oil leaks are

Chapters

Table of Contents

T8020 T8030 T8040