New Holland T8010 Manual page 381

STEP 121
Install two aligning dowels in each bearing retainer
mounting surface of the rear frame.
STEP 122
Install shims as follows:
1. If no changes were made with the differential
bearings, install the original shims back in their
original locations at each bearing retainer. Check
differential rolling torque.
2. Check the backlash on the ring and pinion and
adjust if necessary.
3. When new bearings are installed or the housing
is replaced, the new shim pack dimension
determined by the preload adjustment procedure
must be used. Install half the shim pack under
each bearing retainer (see Adjusting Differential
Preload, beginning at Step 148).
4. Make sure that the lube passages in the rear
frame align with the proper hole in each shim
(see Step 122).
Section 21 - Transmission, Drivelines - Chapter 8
T98192
T98199
21-8-30
STEP 123
Install bearing retainers as follows:
1. Align the lube passage on the rear frame
housing with the lube passage in the bearing
retainer (shown).
2. Install the bearing retainers on the rear frame
housing.
3. Gradually and evenly torque the retainer mounting
bolts to 235 to 260 Nm (173 to 192 lb. ft.).
NOTE: If the differential bearings were changed, the
backlash on the ring and pinion must be set. See
Adjusting the Ring and Pinion Backlash in this
section.
STEP 124
Install the Diff Lock supply line, Diff Lube line, rear
frame cover, and PTO assemblies that were
removed. Install rear frame top cover.
STEP 125
With a 3-point sling and hoist, lift the rockshaft
casting into place.
T98193
35-14