New Holland T8010 Manual page 84

Hide thumbs Also See for T8010:

Table of Contents

Check the torque on the drive shaft hub –

66.7 - 82.6 lb. ft. (90 - 112 Nm).

Check the fan drive, blade assembly, shroud and

radiator for signs of interference with rotating parts. If

damage is present, locate and repair the problem,

replacing defective parts as needed.

Rotate the fan by hand one complete turn (360°).

The fan should turn smoothly with some uniform

internal resistance. If the fan rotates with strong or

non-uniform resistance, replace the fan drive.

NOTE: Fan resistance must result from the internal

drive, not from interference with a non-rotating part.

There should be minimal forward/rearward play in the

fan drive. Grasp the center of the blade assembly,

and attempt to move the drive forward and rearward.

If there is more than 1/16-inch (1.6 mm) play in the

drive itself, replace the fan drive.

NOTE: This Step checks for internal play within the

drive itself, movement which is not the result of loose

mounting bolts or pulley bearing wear.

Section 10 - Engine - Chapter 5

Chapters

Table of Contents

T8020 T8030 T8040