New Holland T8010 Manual page 696

STEP 80
Install the clutch backing disc.
STEP 81
Install the snap ring.
STEP 82
With a depth micrometer, measure the distance from
the top of the hub (1) to the top of the pusher plate
(2) at each pin (3). Average the three measurements.
Record this measurements to obtain "A".
With a depth micrometer, measure the distance from
the backing plate (4) to the top of the hub (5) at three
locations. Average these measurments. Record this
measurement to obtain "B".
If "A" - "B" is less than or equal to 11.235 MM, use
the 3.5 MM brake pusher plate (2).
If "A" - "B" is greater than 11.235 MM, use the 3.0
MM brake pusher plate (2).
Section 31 - PTO - Chapter 2
1
1
31-2-27
3
1
2
4
3
RD05A024
RD05A023
3
RD05N153
5
RD05N154