New Holland T8010 Manual page 563

Hide thumbs Also See for T8010:

Table of Contents

Place the kingpin bearing cap in a press and install a

new inner ring. Use a flat plate to evenly start the

inner ring on the kingpin bearing cap.

Complete the seating of the inner ring on the king pin

bearing cap by using the outer ring as the installer.

Use a bearing installer to install the king pin outer

ring into the axle housing.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

Make sure the outer ring is fully seated in the

housing. Apply a layer of grease to the bearing

Lubricate the inner diameter of a new king pin seal

with grease. Position the new king pin oil seal in the

axle housing.

Use CAS1716-3 Handle and CAS2597 Kingpin Seal

Installer to install the seal.

Chapters

Table of Contents

T8020 T8030 T8040