New Holland T8010 Manual page 830

1. COVER AND GASKET (ON EXPLODED VIEW)
2. SPRING RETAINER
3. COIL SPRING
4. SNAP RING
5. SPRING
1. Remove the cover plate and gaskets (1). Remove the spring retainer (2) and coil spring (3).
2. Remove the snap ring (4) and spring (5).
3. Remove the coupler cartridge (6) from the coupler body (7).
4. Remove the slipper seals (8) and O-rings seals (9). Install new O-rings and slipper seals. Be sure the slipper
seal is in front of the O-ring.
5. Remove the O-ring (10) from the end of the coupler cartridge. Install a new O-ring.
6. Assemble the coupler in reverse order.
Section 35 - Hydraulic Systems, 3PT - Chapter 4
REMOTE COUPLERS
3
35-4-13
2
6
6. CARTRIDGE
7. BODY
8. SLIPPER SEAL
9. O-RING
10. O-RING
9
8
9
8
5
4
10
RI02E027