New Holland T8010 Manual page 934

Installation of the 3-Point Hitch
STEP 27
All six mating surfaces of the hitch support C-bracket
and rear frame must be clean and free of paint, oil,
grease, anti-seize, etc. Move a hitch support C-
bracket into place with a hoist and sling. These
c o m p o n e n t s s h o u l d b e r e p l a c e d w i t h n e w
components during installation:
1. Bushing and seals
2. M24 bolts and nuts
3. Retainers
STEP 28
Attach both hitch support C-brackets to the rear
frame housing. Install new M24 bolts, but do not
tighten. Keep a gap of 5mm between M24 bolt and
bracket. The C-brackets must be free to move easily.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
35-5
35-8
35-11-13
STEP 29
Remove the sling and hoist.
STEP 30
With a sling and hoist, lift the rockshaft casting into
place.
35-10
35-14