New Holland T8010 Manual page 382

STEP 126
The rockshaft pins must be clean and free of oil,
grease, antiseize compound, etc. Orient pin with
bearing surface outboard. Insert a rockshaft pin. Use
a wooden block to tap the pin until it is seated in
place. Insert the other rockshaft pin.
STEP 127
Insert new split washer retainers at the ends of both
rockshaft pins.
Section 21 - Transmission, Drivelines - Chapter 8
35-18
35-30
21-8-31
STEP 128
Install the tie rod as follows:
1. Place one washer and retainer in place on the
end tie rod with the nut.
2. Insert the end of the tie rod without the washer
and retainer through the centers of the rockshaft
pins.
3. Attach the split rings washer and retainer to the
end projecting through the rockshaft pin.
STEP 129
Attach the position sensor bracket.
36s1
36s4