New Holland T8010 Manual page 843

Loader Position
FLOAT
RETRACT DETENT
MOMENTARY
MOMENTARY
EXTEND DETENT
Remote Control Lever Positions - Loader Position
When operating a front end loader the remote
function control MUST be rotated to the loader
position. This prevents the remote control lever from
moving into the detent positions.
WARNING: When doing a loader operation,
the remote function control MUST be in the
loader position. This will prevent the remote
control lever from going into a timed raise
d ete nt. A tim ed d eten t dur i ng l oad er
!
operation can cause uncontrolled loader
operation which may cause load dumping.
Uncontrolled loader operation in a full height
raising of the loader can cause load dumping
which may result in injury or death.
Section 35 - Hydraulic Systems, 3PT - Chapter 5
NEUTRAL
DETENT LOCKED
OUT
M586
35-5-12
Hydraulic Motor Position
FLOAT
RETRACT DETENT
MOMENTARY
NEUTRAL
MOMENTARY
EXTEND DETENT
Remote Control Lever Positions -
Hydraulic Motor Position
Shut off the engine. Move the remote control lever
that the hydraulic motor circuit is connected to
forward to the float position. Rotate the remote
function control to the left over the hydraulic motor
symbol. This will limit the remote control lever to two
operating positions for hydraulic motor applications
only. Retract detent position is to operate the motor
and the float position to stop.
To engage the hydraulic motor, start the engine and
move the remote control lever rearward from the float
position to the retract detent position. The hydraulic
motor will now operate. Use the variable flow control
to regulate the hydraulic motor speed.
To stop driving the hydraulic motor, move the remote
control lever back up to the float position. This will
allow the hydraulic motor to slowly come to a stop.
IMPORTANT: Do not rotate the remote function
control from the hydraulic motor position during
motor applications as it can cause the hydraulic
motor to stop immediately. This will cause damage to
the hydraulic motor, hoses and equipment.
Switch the remote hose coupler positions at the rear
of the tractor to change the direction of rotation of the
motor.
SHIFT HERE TO
OPERATE MOTOR
POSITIONS
LOCKED OUT