New Holland T8010 Manual page 639

4.5-Inch Axle
STEP 45
1
2
Lubricate a new O-ring (1) with transmission fluid or
petroleum jelly and install into the groove in the axle
bushing (2). Press the axle bushing with O-ring
installed on the axle shaft with 89000 N (20 000 lb.)
force so that it is seated tightly on the shoulder.
STEP 46
Press the outer axle bearing on the axle shaft so it is
tight against the bushing.
STEP 47
Put antiseize compound on the OD of the outer
bearing cup. Use a driver to install the bearing cup in
the axle housing until the cup is seated.
Section 27 - Rear Axle - Chapter 1
STEP 48
Put antiseize compound on the OD of the inner
115BSHG
bearing cup. Use a driver to install the bearing cup
into the axle housing until the cup is seated.
STEP 49
115BRG2
Install the axle shaft assembly as follows:
1. Install the axle shaft assembly in the axle
2. Apply a light coat of oil to the bearing cone ID
3. Install the proper spacer over the inner bearing
4. Position a 30-ton ram over the spacer and install
5. Secure in position with a washer and nut.
T97998
27-1-20
2
1
1. RAM
2. SPACER
housing.
and position the bearing on the axle shaft.
cone.
an M20 threaded rod through the ram and into
the axle end.
T97995
3
4
376L0
3. AXLE HOUSING
4. AXLE SHAFT