New Holland T8010 Manual page 318

STEP 263
1
1. Install the emergency brake release supply
fittings (1).
2. Attach a portable hydraulic hand pump to the
fitting and pressurize to 350 PSI (2413 kPa).
Brake should be released and pressure should
hold at or near the original pressurization.If
pressure dose not hold, there is excessive
leakage at the seals and will have to be replaced.
Section 21 - Transmission, Drivelines - Chapter 6
RD05K011
21-6-65
STEP 264
1
1. Install the FWD fitting (1). DO NOT install the
FWD supply tube (2) at this time.
2. Attach a portable hydraulic hand pump to the
fitting and pressurize to 350 PSI (24.1 Bar) (2413
kPa). Because of design, there will be some
leakage in the FWD clutch pack (pressure will
not hold). If there is excessive leakage, (cannot
pump up pressure to 350 PSI (2413 kPa), the
shaft, piston and or hub seals may be damaged
and will have to be replaced.
3. Install the FWD supply tube (2).
2
RD05K012