New Holland T8010 Manual page 822

Removal
IMPORTANT: Always fully lower and disconnect any
implements from the remote hydraulic couplers
before doing service work on the remote valve
sections.
STEP 8
See the Remote Hydraulic System How it Works and
Troubleshooting Section of this Service Manual
before star ting remote valve service. Once it is
determined that repair or replacement is necessary,
follow the procedures in this section.
STEP 9
3
1
2
6
1. VALVE SECTION NO. 1
2. VALVE SECTION NO. 2
3. VALVE SECTION NO. #
The remote valves are located at the rear of the
tractor. Remove the rear cover to access the valves.
Thoroughly clean the remote valves and surrounding
area before performing any service work.
If remote valve sections 1 or 2 are to be serviced, the
hitch valve (6) must be removed first. See the Hitch
Valve Section in this Service Manual for hitch valve
removal procedure.
NOTE: For better valve access, the rear wheels can
be moved out on the axles.
Section 35 - Hydraulic Systems, 3PT - Chapter 4
REMOTE VALVE REMOVAL AND SERVICE
4
5
RI02D103
4. VALVE SECTION NO. 4
5. VALVE SECTION NO. 5
6. HITCH VALVE
STEP 10
1
NOTE: This procedure will depict the removal of
valve sections 4 and 5.
Remove the seven pin connector mounting bracket
(1). Tag and disconnect the wiring harness from the
solenoids (2).
STEP 11
Tag and remove the raise and lower hydraulic tubes
for the 4th and 5th remote sections.
35-4-5
2
RI02E042
RI02E043