New Holland T8010 Manual page 815

Hide thumbs Also See for T8010:

Table of Contents

Install new O-rings on the solenoid cartridges. Install

the cartridges and tighten to a torque of 12 to 18 Nm

(9 to 13 lb. ft.)

Install two new O-rings on the PTO solenoid coil and

install on the cartridge. Install the diff lock solenoid

on to the cartridge. Install the retaining nuts and

tighten to a torque of 5 to 8 Nm (4 to 6 lb. ft.).

NOTE: There are no O-rings on the diff lock

Section 35 - Hydraulic Systems, 3PT - Chapter 3

Assemble the modulator piston (1), modulation

spring (2) and retaining sleeve (3). Apply petroleum

jelly to the steel balls (4) and insert them into the

bore at the end of the modulator spool (5).Push on

the retaining sleeve (3) and compress the modulation

spring (2) a small amount. Install the end of the

modulator piston pin into the modulator spool (5) and

release the retaining sleeve (3).Install the preload

spring (6) onto the assembly.

Install the PTO modulation spool into the valve.

Install the plug and tighten to a torque of 34 to 54 Nm

(25 to 40 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040