New Holland T8010 Manual page 470

STEP 9
The display will read Lock nnnnn mV. The nnnnn
reading is the millivolt reading for the position sensor
output.
P r e s s a n d h o l d d o w n t h e f r o n t s u s p e n s i o n
momentary rocker switch to turn off both the raise
and lower lockout solenoids. This can be used to
troubleshoot the raise and lower lockout circuits. Use
a multimeter to check the voltage at the lockout
solenoids. Release the rocker switch and both
lockout solenoids will be energized again.
Press the DECR key.
STEP 10
The display will read Exit Manual. Press the PROG
key.
Section 25 - Four-Wheel Drive Front Axle - Chapter 5
RD06A033
RD06A034
25-5-15
STEP 11
The display will read Fus Manual. Press the DECR
key.
STEP 12
Press the DECR key until Exit Fsus is displayed.
Press the PROG key.
STEP 13
The display will read TRANS FSUS. Use the DECR
key to select TRANS EXIT. Turn ignition key to OFF.
RD06A030
RD06A035
RD06A024