New Holland T8010 Manual page 217

Hide thumbs Also See for T8010:

Table of Contents

Install the centering sleeve CAS1903-4 over the

Install snap ring as follows:

1. Install the snap ring over the centering sleeve.

2. Install the Belleville washer compression sleeve

CAS1903-5 over the shaft and centering sleeve.

The compression sleeve will rest on top of the

NOTE: The smaller OD side of the sleeve must be

Section 21 - Transmission, Drivelines - Chapter 4

Install the sleeves and snap ring as follows:

1. Install the compression sleeve with the notch

over the shaft.

2. Use a hydraulic press to press the sleeves down.

The snap ring will be pushed into position in the

groove with the pin between the snap ring ends.

3. Verify that the snap ring is properly seated in the

Install a separator plate.

NOTE: 1st and 3rd clutch does not use a reaction

plate (thicker than separator plate).

Chapters

Table of Contents

T8020 T8030 T8040