New Holland T8010 Manual page 287

Hide thumbs Also See for T8010:

Table of Contents

Turn the shaft assembly over and use a hydraulic

press to push the shaft through the remaining parts.

NOTE: Be careful not to let the shaft fall through.

Remove the front bearing cone and front bearing

cone spacer.

Remove the two bearing thrust washers and the

needle thrust bearing.

Section 21 - Transmission, Drivelines - Chapter 6

Remove the four seal rings from the hub on the gear

(two rings in each of two grooves).

Turn the low range driven gear and clutch plate

carrier over and remove the snap ring.

Carefully tur n the assembly over and remove

backing, friction, and separator plates.

Chapters

Table of Contents

T8020 T8030 T8040