New Holland T8010 Manual page 230

Hide thumbs Also See for T8010:

Table of Contents

Install the reaction plate (thicker separator plate).

Install a new friction plate.

NOTE: Dip all friction plates in clean transmission

Install a separator plate. Install the remaining 6 new

friction plates and 5 separator plates, alternating the

plates and plates.

Section 21 - Transmission, Drivelines - Chapter 4

Install the backing plate. The flat side must be facing

Install the snap ring.

Install the needle thrust bearing and the two bearing

thrust washers.

NOTE: The needle thrust bearing must be between

the two bearing thrust washers.

Chapters

Table of Contents

T8020 T8030 T8040