Assembly - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Assembly

Lubricate the new O-rings and backup ring with

petroleum jelly. Install two new O-rings on the poppet

body. Install a new backup ring and a new O-ring on

the lower pilot and spring assembly. The backup ring

will be on top of the O-ring. Lubricate all parts with

clean hydraulic fluid.

Install the lower poppet, lower pilot and spring

assembly and the popper body into the valve.

Tighten the poppet body to a torque of 21 to 27 Nm

(15 to 20 lb. ft.).

Lubricate the new O-rings with petroleum jelly. Install

two new O-rings on the overload relief body. Install

the spring and poppet with shims into the body.

Install the assembly into the valve. Tighten the body

to a torque of 14 to 28 Nm (10 to 21 lb. ft.).

Section 35 - Hydraulic Systems, 3PT - Chapter 10

Install the load sense check into the valve.

Use a 3/16 inch allen wrench and tighten the check

to a torque of 8 to 13 Nm (6 to 10 lb. ft.). Install the

tee fitting.

Lubricate the new O-ring with petroleum jelly. Install

the O-ring onto the plug. Install the ball, spring and

plug. Tighten the plug to a torque of 14 to 28 Nm (10

to 21 lb. ft.).

Table of Contents

T8020 T8030 T8040