STEP 174
Remove the caged needle bearing and the two
bearing thrust washers and needle thrust bearing.
STEP 175
Remove the snap ring from inside the clutch plate
carrier.
STEP 176
Remove the backing plate, friction plates and
separator plates.
Section 21 - Transmission, Drivelines - Chapter 4
A11566
T95460
T95461
21-4-49
STEP 177
Install the compression sleeve CAS1903-3 with the
notch over the piston return Belleville washers. The
opening in the sleeve must be over the ends of the
snap ring. Compress the Belleville washers with a
hydraulic press and remove the snap ring.
STEP 178
Remove the piston return Belleville washers and lube
m an a ge m en t r in g . N ot e o r i e nt a ti o n fo r la t er
installation.
T95469
T95471