New Holland T8010 Manual page 555

Hide thumbs Also See for T8010:

Table of Contents

Remove the cotter pin from the tie rod socket end

slotted nut. Loosen the slotted nut. Unseat the tie rod

socket end from the steering knuckle, using a soft

metal hammer. Remove the slotted nut and the tie

rod end. Remove the opposite tie rod end using the

same procedure, if necessary.

Properly support the steering knuckle to retain the

position of the upper king pin bearing cap, when it is

Remove the three upper king pin bearing cap bolts.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

Remove the upper king pin bearing cap (1) and the

Install lifting eyes and properly support the steering

knuckle. Remove the lower king pin bearing cap and

Remove the planetary input sun gear shaft oil seal

from the steering knuckle. Press the planetary input

sun gear shaft bushing from the steering knuckle, if

replacement is necessary.

Chapters

Table of Contents

T8020 T8030 T8040