New Holland T8010 Manual page 938

Hide thumbs Also See for T8010:

Table of Contents

Insert a holding pin as follows:

1. Pin must be clean and free of oil, grease, anti-

2. Adjust the vertical position of the rockshaft, if

3. Move the upper end of the shaft into place so

that the hole in the shaft of the hitch lift cylinder is

aligned with its mating holes. Position both sides

before proceeding to the next task in this step.

4. Insert the holding pin through the holes.

Install the bolt, washer, spacer and nut. Tighten to a

torque of 82 to 106 Nm (60 to 70 lb. ft.). Be sure the

locking plate and slot are positioned correctly to

prevent damage to plate. Repeat for opposite side.

Section 35 - Hydraulic Systems, 3PT - Chapter 11

Attach the hydraulic line to the top of the hitch.

Repeat for the other hitch lift cylinders.

Attach a vertical lift link as follows:

1. Pin must be clean and free of oil, grease, anti-

2. Place a hitch swivel pin part-way through the

outside hole in the upper end of a vertical lift link.

3. Lift the link into position.

4. Insert the hitch swivel pin into the mating holes.

Chapters

Table of Contents

T8020 T8030 T8040