STEP 83
Align the teeth of the friction plates as shown.
STEP 84
Place the clutch pack assembly over the hub, making
sure all friction plate teeth are engaged in the
splines.
NOTE: It may be necessary to rotate and LIGHTLY
tap the end of the clutch carrier to align the friction
brake teeth with the splines.
IMPORTANT: BE SURE not to break any friction
brake teeth during installation.
STEP 85
Press down on the clutch carrier and install the snap
ring.
STEP 86
Air test the piston pressure port for seal ring leakage.
NOTE: Some air leakage will occur. If leakage is
excessive, sealing ring may have been damaged
during assembly and will need to be replaced.
Section 31 - PTO - Chapter 2
1
1
31-2-28
RD05B027
RD05D024
3
RD05A019
RD05D025
3