New Holland T8010 Manual page 821

Hide thumbs Also See for T8010:

Table of Contents

Remove the cap (1) from the load check body (2).

There will be a light load from the spring (3). Make

sure the stem (4) on the main poppet (5) is in place.

Inspect the poppet and poppet seat for wear or

Replace all backup rings and O-rings. Assemble the

Section 35 - Hydraulic Systems, 3PT - Chapter 4

Install the load check assembly and plunger into the

valve section. Tighten the cap to a torque of 30 t0 41

Nm (22 to 30 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040