Single Speed Reversible Shaft Pto Driven Gear; Removal - New Holland T8010 Manual

SINGLE SPEED REVERSIBLE SHAFT PTO DRIVEN GEAR

Before servicing the PTO Driven Gear, the following will be necessary:
Remove the cab (See Cab Removal Section).
Remove the rockshaft (See Hitch Removal Section).
Remove the final drive top cover (See Final Drive Section).
Remove PTO clutch assembly (See PTO Assembly Section).
Remove PTO drive assembly (See PTO Assembly Section).
STEP 116
Remove the four oil shield retaining clips.
NOTE: Hitch components and draw bar rear support
are removed for photographic purposes.
STEP 117
Lift the gear (1) and rear half of the shield (2) out as a
unit through the top of the final drive housing.
STEP 118
Remove the six PTO driven gear bearing cage
retaining bolts.
Section 31 - PTO - Chapter 2

Removal

31-2-39
1
RD05B019
2
RD05A058
RD05A055