STEP 86
Remove the two bearing thrust washers and the
needle thrust bearing.
STEP 87
Install the compression sleeve CAS1903-3 with the
notch over the piston return Belleville washer. The
opening in the sleeve must be over the ends of the
snap ring. Compress the Belleville washers with a
hydraulic press and remove the snap ring from both
sides of the clutch plate carrier.
Section 21 - Transmission, Drivelines - Chapter 4
T95327
A11518
21-4-28
STEP 88
Remove the piston return Belleville washers and lube
management ring from each side of the clutch plate
carrier.
IMPORTANT: Note orientation of Belleville washers
and lube management ring for later installation.
STEP 89
Remove the carrier retaining snap ring from each
side of the clutch plate carrier.
T95331
T95332a