New Holland T8010 Manual page 506

Hide thumbs Also See for T8010:

Table of Contents

Setting The Pinion Depth

Install the outer bearing cup.

The pinion depth setting tool, FNH 00400 or

30001109, must be assembled into the differential as

shown above. Follow Steps 60 through 64 to

assemble tool to differential housing.

Install the Handle FNH 00401 or 380001132 and

Threaded Shaft FNH 00402 or 380001133 into the

carrier housing.

Section 25 - Four-Wheel Drive Front Axle - Chapter 8

Install Aligning Disc FNH 00405 or 380001136 and

the Gauge Disc FNH 00403 or 380001134.

Install Gauge Block FNH 00404 or 380001135 and

finger tighten to hold the gauge assembly and

bearing cones in position.

Install the Tube FNH 00406 or 380001137.

Chapters

Table of Contents

T8020 T8030 T8040