Steering Knuckle And Kingpin Disassembly - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

STEERING KNUCKLE AND KINGPIN DISASSEMBLY

Place an identifying mark on the wheel stop before

removing the clevis locking pin. Remove the clevis

retaining pin (1), the clevis locking pin (2), and the

wheel stop (3).

Remove the cotter pin from the slotted nut on the

steering cylinder socket end.

Loosen, do not remove, the steering cylinder socket

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

Remove the cotter pin from the lower end of the

steering cylinder clevis pin at the axle housing.

Remove the clevis pin. Remove and discard the

clevis pin bushing O-rings.

With the slotted nut in place on the steering cylinder

socket end, unseat the steering cylinder socket end

from the steer ing knuckle, using a soft metal

hammer. Remove the slotted nut and remove the

cylinder. Remove the opposite steering cylinder

using the same procedure, if necessary.

Table of Contents

T8020 T8030 T8040