STEP 46
Install the plate/disc stack into the differential
housing. The end of the stack with 3 plates goes to
the in board side.
Assemble the differential case halves. Make sure the
marks line up on the case halves. Refer to the
alignment marks made prior to disassembly. Install
eight (8) new differential case screws. Tighten to a
torque of 122 to 135 Nm (90 to 100 lb. ft.).
Section 25 - Four-Wheel Drive Front Axle - Chapter 8
RR99K229
STEP 47
Install the differential ring gear to the housing half.
Install new ring gear bolts. Tighten the ring gear bolts
to a torque of 163 to 190 Nm (120 to 140 lb. ft.). (Use
a 13/16 inch socket).
NOTE: Make sure the discs and plates are kept in
the same order as disassembly.
25-8-14
RR98K035