New Holland T8010 Manual page 488

Hide thumbs Also See for T8010:

Table of Contents

Remove the axle supports and lower the front axle.

Remove the wedges (arrows).

Install the drive shaft at the transmission output

flange, using the alignment marks made during

disassembly. Slide the drive shaft protector on the

drive shaft and install a new plastic pin. Install the

drive shaft at the front axle pinion flange, using the

alignment marks. Tighten the drive shaft bolts to a

torque of 58 to 64 Nm (43 to 47 lb. ft.).

Section 25 - Four-Wheel Drive Front Axle - Chapter 7

Install the axle shield (1). Install and tighten the two

shield retaining bolts (2). Properly support and install

the tractor front weights. Check the hydraulic fluid

level and add if necessary. Remove rear axle wheel

blocks. Start the tractor. Check for leaks. Check front

axle operation and front fender to wheel clearance, if

equipped. Place the tractor in Park, turn the ignition

off, and remove the key.

Chapters

Table of Contents

T8020 T8030 T8040