New Holland T8010 Manual page 445

STEP 35
Install the FWD output shaft into the needle bearing
in the rear wall of the speed housing. Engage the
FWD output shaft with the FWD hub spline. Install
the four bolts through the output shaft bearing cage
and the drop box. Tighten the four bolts to a torque of
375 to 485 Nm (276 to 358 lb. ft.).
Section 25 - Four-Wheel Drive Front Axle - Chapter 3
11S19
25-3-14
STEP 36
2
Install the FWD drive shaft and the drive shaft
protector. Refer to the installation procedure
contained in this manual. Properly support the drive
shaft. Tighten the drive shaft retaining bolts (1) to a
torque of 58 to 64 Nm (43 to 47 lb. ft.). Install the
drive shaft protector pins (2), using the position
marks on the drive shaft protector made during
disassembly.
NOTE: Suspended FWD axle shown. The procedure
will be similar for all FWD axles.
1
RD02H173
RD02H172