New Holland T8010 Manual page 917

Hide thumbs Also See for T8010:

Table of Contents

Lubricate the new O-ring with petroleum jelly. Install

the O-ring onto the plug. Lubricate the raise spool

with clean hydraulic fluid and install the spool into the

valve. Install and tighten the plug to a torque of 14 to

28 Nm (10 to 21 lb. ft.).

Lubricate the new O-rings with petroleum jelly. Install

two new O-rings onto the raise solenoid core.

Lubricate the pilot spool, control pin and solenoid

core with clean hydraulic fluid and install into the

valve. Tighten the core to a torque of 14 to 28 Nm (10

to 21 lb. ft.).

Repeat the procedure for the lower solenoid core.

Section 35 - Hydraulic Systems, 3PT - Chapter 10

Install the coils and coil nuts. Tighten the coil nuts to

a torque of 2 to 4 Nm (17 to 35 lb. in.).

Chapters

Table of Contents

T8020 T8030 T8040